EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 36)

3.2.4. Full Control and Lever Control
You control both PGM and PRV when the PRV CTL key is not active.
Once you select PRV CTL, you gain control on the PRV channel with the jog dial and
most keys, while the lever and the PLAY key control the PGM output. At this point,
selecting clips will call them up on the PRV channel.
Activating both the PRV CTL and the SW to IN functions allows the operator to auto-chain
cameras from the same IN point.
Let's say an IN point has been marked, and you activate the PRV CTL and sets to ON the
SW to IN option: The slow motion of one camera can be started from this IN point. The
operator selects another camera in the PRV output and, via the TAKE button, can auto-
chain cameras from the same IN point on the PGM output.
3.3. Multi PGM Mode
3.3.1. Multi PGM Overview
Introduction
Multicam has two modes for its basic operation, 1PRV+PGM and Multi PGM:
• The 1PGM+PRV mode is more powerful as it allows interaction between all outputs.
Synchronized replays can be rolled and chained between the cameras with either a
mix, a wipe, or a cut between them.
• The Multi PGM mode is more basic but gives the operator independent control of all
outputs. These outputs can be controlled together (such as jogging back to a certain
action on all outputs) or individually (either PGM 1, 2, or 3).
26 3. Control Modes
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013