Xerox 785 - Manual (Page 199)

Reports
WorkCentre Pro 665/685/765/785 9-5
Confirmation Report Setup
Confirmation Reports can automatically be printed by the WorkCentre
following each transmission, or only following transmissions where an
error occurred. Using the setup procedure you can select which type
of transmissions automatically print a Confirmation Report, and under
which conditions the report is printed:
•
Always — Prints a report after every communication.
•
On Error — Prints a report only when an error occurs.
• Off — A report is not automatically printed.
In addition, you can set the WorkCentre to print the first page* of the
fax on the report for Memory Send, Group Send, Relay Originator,
Relay Station, and Relay Destination reports.
Automatic Confirmation Reports are available for the following
operations:
•
Confirmation Report — Prints transmission results for a Direct
Send transmission.
•
Confirmation Report – Memory Send — Prints Memory Send
Transmission results.
•
Group Send Report — Prints Group Transmission results.
•
Group Poll Report — Prints Group Polling Transmission results.
•
Relay Originator Report — Prints results for Relay
Transmissions initiated by the Originator Station.
• Relay Station Report — Prints results for Relay Transmissions
initiated by the Relay Station.
•
Relay Destination Report — Prints Relay Destination Station
results sent from the Relay Station to the Originator Station, and
printed by the Originator Station.
* Not allowed in all markets.