ZyXEL Communications XGS-4728F - Manual (Page 91)

Chapter 8 Basic Setting
XGS-4728F User’s Guide
91
BPDU
Control Configure the way to treat BPDUs received on this port. You must activate
bridging control protocol transparency in the Switch Setup screen first.
Select Peer to process any BPDU (Bridge Protocol Data Units) received on
this port.
Select Tunnel to forward BPDUs received on this port.
Select Discard to drop any BPDU received on this port.
Select Network to process a BPDU with no VLAN tag and forward a tagged
BPDU.
CX4 Cable Select the number of meters for the length of the 10GBASE-CX4 cable you
use to connect between the Switch and another switch for stacking.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 15 Basic Setting > Port Setup (continued)
LABEL DESCRIPTION