3 ospf configuration – ZyXEL Communications XGS-4728F User Manual
Page 278
Chapter 32 OSPF
XGS-4728F User’s Guide
278
32.3 OSPF Configuration
Use this screen to activate OSPF and set general settings. Click IP Application >
OSPF and the Configuration link to display the OSPF Configuration screen.
See
for more information on OSPF.
Figure 149 IP Application > OSPF Configuration: Activating and General Settings
The follow table describes the related labels in this screen.
Seq #
This field displays the link sequence number of the LSA.
Checksum
This field displays the checksum value of the LSA.
Link Count
This field displays the number of links in the LSA.
Table 97 OSPF Status: Common Output Fields (continued)
FIELD
DESCRIPTION
Table 98 IP Application > OSPF Configuration: Activating and General Settings
LABEL
DESCRIPTION
Active
OSPF is disabled by default. Select this option to enable it.
Router ID Router ID uniquely identifies the Switch in an OSPF. Enter a unique ID (that
uses the format of an IP address in dotted decimal notation) for the Switch.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the Save
link on the top navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.