ZyXEL Communications XGS-4728F - Manual (Page 342)

Chapter 39 Access Control
XGS-4728F User’s Guide
342
39.3.5 Configuring SNMP Trap Group
From the SNMP screen, click Trap Group to view the screen as shown. Use the
Trap Group screen to specify the types of SNMP traps that should be sent to each
SNMP manager.
Figure 204 Management > Access Control > SNMP > Trap Group
The following table describes the labels in this screen.
Privacy Specify the encryption method for SNMP communication from this user.
You can choose one of the following:
• DES - Data Encryption Standard is a widely used (but breakable)
method of data encryption. It applies a 56-bit key to each 64-bit
block of data.
• AES - Advanced Encryption Standard is another method for data
encryption that also uses a secret key. AES applies a 128-bit key to
128-bit blocks of data.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 130 Management > Access Control > SNMP (continued)
LABEL DESCRIPTION
Table 131 Management > Access Control > SNMP > Trap Group
LABEL DESCRIPTION
Trap
Destination IP Select one of your configured trap destination IP addresses. These are
the IP addresses of the SNMP managers. You must first configure a trap
destination IP address in the SNMP Setting screen.
Use the rest of the screen to select which traps the Switch sends to that
SNMP manager.
Type Select the categories of SNMP traps that the Switch is to send to the
SNMP manager.