ZyXEL Communications XGS-4728F User Manual
Page 55
Chapter 4 The Web Configurator
XGS-4728F User’s Guide
55
1
Connect to the console port using a computer with terminal emulation software.
See
for details.
2
Disconnect and reconnect the Switch’s power to begin a session. When you
reconnect the Switch’s power, you will see the initial screen.
3
When you see the message “Press any key to enter Debug Mode within 3
seconds ...
” press any key to enter debug mode.
4
Type atlc after the “Enter Debug Mode” message.
5
Wait for the “Starting XMODEM upload” message before activating XMODEM
upload on your terminal.
6
After a configuration file upload, type atgo to restart the Switch.
Figure 19 Resetting the Switch: Via the Console Port
The Switch is now reinitialized with a default configuration file including the default
password of “1234”.
ZyNOS Version: V3.90(BBC.0)b1 | 04/28/2009 09:20:42
Bootbase Version: V1.00 | 10/22/2007 12:48:50
RAM:Size = 128 Mbytes
DRAM POST: Testing:131072K OK
DRAM Test SUCCESS !
FLASH: Intel 64M
ZyNOS Version: V3.90(BBC.0)b1 | 04/28/2009 09:20:42
Press any key to enter debug mode within 3 seconds.
.....................................
Enter Debug Mode
ras> atlc
Starting XMODEM upload (CRC mode)....
CCCCCCCCCCCCCCCC
Total 393216 bytes received.
Erasing..
................................................................
OK
ras> atgo