ZyXEL Communications XGS-4728F - Manual (Page 254)

Chapter 26 IP Source Guard
XGS-4728F User’s Guide
254
Apply Click this to display the specified range of VLANs in the section
below.
VID This field displays the VLAN ID of each VLAN in the range
specified above. If you configure the * VLAN, the settings are
applied to all VLANs.
Enabled Select Yes to enable ARP inspection on the VLAN. Select No to
disable ARP inspection on the VLAN.
Log Specify when the Switch generates log messages for receiving
ARP packets from the VLAN.
None: The Switch does not generate any log messages when it
receives an ARP packet from the VLAN.
Deny: The Switch generates log messages when it discards an
ARP packet from the VLAN.
Permit: The Switch generates log messages when it forwards an
ARP packet from the VLAN.
All: The Switch generates log messages every time it receives an
ARP packet from the VLAN.
Apply Click Apply to save your changes to the Switch’s run-time
memory. The Switch loses these changes if it is turned off or
loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are
done configuring.
Cancel Click this to reset the values in this screen to their last-saved
values.
Table 87 ARP Inspection VLAN Configure (continued)
LABEL DESCRIPTION