Yamaha TG500 - Manual (Page 78)

66
3-1-05: TUNE
The fine tune parameters allow slight upward or downward pitch adjustment of
each layer, making it possible to create voice-thickening detune effects between
layers.
PERFORMANCE EDIT MODE / 3: Full Edit. 3-1: Layer
3: Full Edit. 3-1: Layer
Tune (layer A)
PFM Tune [A] WN Flut1
0я 0я 0я 0я
The layer to be edited can be selected as described on page 50. The currently
selected layer is shown in square brackets on the upper display line.
Fine (Fine tuning)
Range: -7 … +7
Use the [
,] and [.] keys (or the standard layer selection procedure) to select
the layer to be edited, then use the [-1/NO] and [+1/YES] keys to adjust the
pitch of the voice assigned to that layer. The maximum minus setting of
“-7” produces a downward pitch shift of approximately 2 cents (a “cent” is 1/
100th of a semitone), and the maximum plus setting of “+7” produces an
upward pitch shift of approximately 2 cents. A setting of “0” produces no pitch
change.
The Fine parameter allows different layers in a performance combination to
be slightly detuned in relation to each other, thereby “thickening” the overall
sound.
The name of the currently selected voice is shown in the upper right corner
of the display (“--------” appears if the voice is turned off). An animated musi-
cal note appears to the right of voices that are on and active (i.e. not muted).
[PLAY MODE] -> PFM PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-1:Layer -> [ENTER]
-> [PAGE] -> 3-1-05 : Tune -> [ENTER]