Yamaha TG500 - Manual (Page 154)

142
3-6-02: AFTER TOUCH DEPTH
VOICE EDIT MODE / 3: Full Edit. 3-6: Controller
For truly “intimate” modulation control, the TG500 allows a number of modula-
tion effects to be controlled via keyboard aftertouch response. The parameters in this
screen set the depth of the aftertouch modulation effects.
VCE CTRL AT Depth
3 5 0 20 é
3-6-02: AFTER TOUCH DEPTH
VCE CTRL AT Depth
è -6 4 127 0
Amod (Amplitude modulation depth)
Range: 0 … 127
Sets the maximum depth of amplitude modulation (tremolo effects) applied
via keyboard aftertouch.
A setting of “0” allows no amplitude modulation, while a setting of 127
results in maximum amplitude modulation depth.
When setting up the low-frequency oscillator to apply amplitude modula-
tion, this parameter must be set to a value other than “0” if amplitude modula-
tion is to be applied via keyboard after touch.
Pmod (Pitch modulation depth)
Range: 0 … 127
Sets the maximum depth of pitch modulation (vibrato effects) applied via
keyboard aftertouch.
A setting of “0” allows no pitch modulation, while a setting of 127 results
in maximum amplitude modulation.
When setting up the low-frequency oscillator to apply pitch modulation, this
parameter must be set to a value other than “0” if pitch modulation is to be
applied via keyboard aftertouch.
Fmod Pmod Amod
Cof PtBs EGBs
[PLAY MODE] -> VCE PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-6: Controller -> [ENTER]
-> [PAGE] -> 3-6-02: AT Depth -> [ENTER]