Yamaha TG500 User Manual
Page 41
3. The Performance Mode
29
3-2
Press [ENTER], then use the [-1/NO] and [+1/YES] keys to select the “3-
1:Layer” screen.
When you’ve located this screen, press [ENTER] to engage the performance
edit “Layer” mode.
4
Select the Voices for Each Layer
If the “PFM Voice” display doesn’t appear as soon as you engage the
performance layer mode, press [PAGE], use the [-1/NO] and [+1/YES] keys to
select the “3-1-01:Voice” screen, then press [ENTER].
The voice numbers assigned to each layer are shown across the bottom of
the display. After initialization, voice “P
I
00” is assigned to all four layers.
Use the [
,] key to place the underline cursor under the layer-A voice
number (note that the selected layer is shown in square brackets and the voice
name is shown in the upper right corner of the display), then use the [-1/NO]
and [+1/YES] keys to select voice number “P
I
06” (BA Wood).
Next press the [
.] key to select the layer-B voice number, and use the
[-1/NO] and [+1/YES] keys to select voice number “P
I
04” (AP Tack).
Next press the [
.] key to select the layer-C voice number, and select voice
number “P
IV
21” (ST Pizz).
Finally, move the cursor to the layer-D voice number and, while holding
the [UTILITY/SELECT] key, press the [MEMORY] key to turn layer-D “off”
(page 50).
PFM EDIT
É00œ:InitPerf
3-1:Layer
PFM Voice [A] AP Grand
Й00‹ Й00‹ Й00‹ Й00‹
PFM Voice [A] BA Wood
Й06‹ Й04‹ Ь21‹ off
Layer “A”
voice.
Layer “B”
voice.
Layer “C”
voice.
Layer “D”
voice.