Yamaha TG500 - Manual (Page 243)

231
UTILITY MODE / WAVE EDIT MODE / 3: MIDI
3-3: BULK DUMP
3-3: BULK DUMP
Initiates MIDI bulk transmission of the selected voice, performance, multi-play,
and/or system data.
UTL MIDI Bulk Dump
Type= 1:all
Type
Range: all, 1 PFM, 1VCE, 1 MLT
The various data types are as follows:
1: all All internal data.
2: 1 PFM The currently selected performance combination.
3: 1 VCE The currently selected voice.
4: 1 MLT The currently selected multi setup.
Press [ENTER] to begin the bulk dump procedure. The following confirmation
display will appear:
Press [+1/YES] to confirm that you want to go ahead with the bulk dump opera-
tion, or press [-1/NO] to cancel.
“Executing!” appears on the display while the data is being transmitted (no other
operations can be performed during transmission). When the data has been transmit-
ted, “Completed!” will appear briefly on the display.
This function is useful for transferring synthesizer, and/or system data from one
TG500 to another. If the MIDI OUT of the transmitting TG500 is connected to the
MIDI IN of the receiving TG500 via a MIDI cable, the receiving unit will automati-
cally receive and load the data as long as its BULK RECEIVE PROTECT (page 230)
function is turned “off” and it is set to the same device number as the transmitting
TG500. Another possibility is to transfer the data to an external MIDI bulk data
storage device for long-term storage.
[UTILITY/SELECT] -> 3: MIDI -> [ENTER] -> [PAGE] -> 3-3: Bulk Dump -> [ENTER]