Yamaha TG500 - Manual (Page 220)

208
MULIT EDIT MODE / 4: Effect
4-04: OUTOUT
4-04: OUTPUT
These parameters turn the “dry lines” (i.e. the signal paths which bypasses each
effect processor) on or off, determining whether any dry signal output can occur at
OUTPUT 1 and OUTPUT 2.
MLT Output [ 1]
Dry1: o n Dry2: on
The instrument to be edited is selected as described on page 198. The currently
selected instrument is shown in square brackets on the upper display line.
Dry1
Range: off, on
Turns the “dry line” bypassing the EFFECT 1 signal processor on or off.
When this parameter is turned “off,” the “WET:DRY” parameters (page 210)
have no effect. If the “Src” in parameter in the proceding screen is set to
“VCE” or “PFM”, this parameter cannot be edited (“---” appears on the dis-
play).
Dry2
Range: off, on
Turns the “dry line” bypassing the EFFECT 2 signal processor on or off.
When this parameter is turned “off,” the “WET:DRY” parameters (page 210)
have no effect. If the “Src” in parameter in the proceding screen is set to
“VCE” or “PFM”, this parameter cannot be edited (“---” appears on the dis-
play).
[PLAY/MODE] -> MLT PLAY -> [EDIT/COMPARE] -> [PAGE] -> 4: Effect -> [ENTER] -> [PAGE]
-> 4-04: Output -> [ENTER]