Yamaha TG500 User Manual
Page 294
282
Appendix
EFFECTS
Turn the TG500 power switch off and
disconnect the AC power cord from the
main outlet.
Locate the small cover on the top of
the TG500 and remove the two screws that
hold it in place (Figure 1).
Below the cover you will see a recessed
panel (Figure 2). When installing a single
SYEMB06 use slot number 1. Install a
second SYEMB06 in slot number 2.
Replace the cover and secure it with the
screws you removed in step 2.
Installation of the SYEMB06
Expansion Memory Board
Installation of the SYEMB06 Expansion Memory Board
1
2
3
4
SYEMB06
Cover
Figure 1
Figure 2
The wave memory must be initialized after installation of the SYEMB06.
WARNING: Installation of a SYEMB06 may cause the internal data to be damaged.
Backup the internal data before installation.