Yamaha TG500 - Manual (Page 157)

145
3-6-03: MIDI CONTROLLER 1 / 3-6-04: MIDI CONTROLLER
2
VOICE EDIT MODE / 3: Full Edit. 3-6: Controller
3-6-03: MIDI CONTROLLER 1 / 3-6-04: MIDI CONTROLLER 2
The parameters in these two screens set the maximum depth of modulation that
can be produced by “MC1” (MIDI Controller 1) and “MC2” (MIDI Controller 2).
VCE CTRL MC1 Depth
(Mod.Whl.) 0 28 0é
VCE CTRL MC1 Depth
è(Mod.Whl.) +2 0 0
MIDI controller assignments are made via the “UTILITY” mode “2:Controller” screen
— page 223.
Amod (Amplitude modulation depth)
Range: 0 … 127
Sets the maximum depth of amplitude modulation (tremolo effects) applied
via MIDI controller 1 or 2.
A setting of “0” allows no amplitude modulation, while a setting of 127
results in maximum amplitude modulation depth.
When setting up the low-frequency oscillator to apply amplitude modula-
tion, this parameter must be set to a value other than “0” if amplitude modula-
tion is to be applied via MIDI controller 1 or 2.
Pmod (Pitch modulation depth)
Range: 0 … 127
Sets the maximum depth of pitch modulation (vibrato effects) applied via
MIDI controller 1 or 2.
A setting of “0” allows no pitch modulation, while a setting of 127 results
in maximum amplitude modulation.
When setting up the low-frequency oscillator to apply pitch modulation, this
parameter must be set to a value other than “0” if pitch modulation is to be
applied via MIDI controller 1 or 2.
Fmod
EGBs Cof
Amod
Pmod
[PLAY MODE] -> VCE PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-6: Controller -> [ENTER]
-> [PAGE] -> 3-6-03: MIDI Ctrl 1 -> [ENTER]
-> [PAGE] -> 3-6-04: MIDI Ctrl 2 -> [ENTER]