2: sample transmit, Utl sample trans. sample= 0 5, Utl sample trans. sure? sample= 0 5 – Yamaha TG500 User Manual

Page 259

247

UTILITY MODE / WAVE EDIT MODE / 4: Sample Dump

4-2: SAMPLE TRANSMIT

UTL Sample Trans.

sample= 0

This function initiates transmission of MIDI Sample Dump data to an external

MIDI device.

sample (Sample number)

Range: 00 … 63

This parameter specifies the number of the sample to be transmitted

(“--” appears on the display if no samples are available).

When ready to transmit the data, press the [ENTER] key. The following

confirmation display will appear:

UTL Sample Trans. Sure?

sample= 0

Press [+1/YES] to confirm that you want to go ahead with the transmission,

or press [-1/NO] to cancel.

“Executing” appears while the data is being transmitted.
The [EXIT] key can be used to cancel transmition at any time.
A key symbol will appear next to the sample number if the sample is a

protected sample that has been loaded from a waveform card. Protected samples
cannot be transmitted.

[UTILITY/SELECT] -> 5: Wave -> [ENTER] -> [EDIT/COMPARE] -> 4: Sample Dump -> [ENTER] -> [PAGE]
-> 4-2: Sample Transmit -> [ENTER]