Yamaha TG500 - Manual (Page 153)

141
3-6-01: PITCH BEND, AFTER TOUCH
VOICE EDIT MODE / 3: Full Edit. 3-6: Controller
This screen includes parameters that set the TG500’s pitch bend range and the
aftertouch mode.
VCE CTRL
PB_Range= 2 AT= ch's
3-6-01: PITCH BEND, AFTER TOUCH
PB_Range (Pitch bend range)
Range: 0 … 12
Sets the maximum pitch bend range.
Each increment from “0” to “12” represents a semitone. A setting of “0”
produces no pitch bend. A setting of “12” allows a maximum pitch bend of
plus or minus one octave, while a setting of “4” allows a maximum pitch bend
of plus or minus a major third.
AT (Aftertouch mode)
Range: ch’s, key’s
Selects the channel or individual (polyphonic) key aftertouch response
mode. If “ch’s” is selected, the channel aftertouch response mode is engaged
and only a single aftertouch value is received via a single MIDI channel. If
“key’s” is selected, the individual key aftertouch repsonse mode is engaged and
individual aftertouch values are recognized for every note played.
[PLAY MODE] -> VCE PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-6: Controller -> [ENTER]
-> [PAGE] -> 3-6-01: PB, AT -> [ENTER]