Connect the fpc to the connector on the source pcb – Toshiba M10 User Manual

Page 361

Text mode
Original mode

4.33 TFT FL (Model 15.0 SXGA+ SHARP LQ150F1LH43)

4 Replacement Procedures

Satellite Pro M10 Series Maintenance Manual (960-431)

4-149

13. Connect the FPC to the connector on the source PCB.

Make sure the latch secures the connector correctly.
See the notches on both the edge of the FPC, and
see the contour of the connector.
Insert the FPC into the connector firmly. The FPC
must have no inclination. Lock the connector firmly.

NG: The FPC has inclination.

NG: The FPC does not connect firmly.

Screw

Tighten the screws with 0.9 kgf•cm of torque.

Align the holes on the PCBs with the pins.

Gate PCB

Source PCB

Screw

FPC

Do not let the PCB lie
on the rib of the frame.

Figure 4-121 Securing the PCBs and connecting the FPC