Toshiba M10 - Manual (Page 301)

4.27 TFT FL (Model 14.1 XGA Samsung LTN141XF-L02) 4 Replacement Procedures
Satellite Pro M10 Series Maintenance Manual (960-431) 4-89
Installing the TFT FL (Model 14.1 XGA Samsung LTN141XF-L02)
To install the TFT FL (Model 14.1 XGA Samsung LTN141XF-L02), follow the steps below
and refer to Figures 4-57 to 4-65.
1. Place the FL tube on the correct location in the frame.
2. Connect the ground wire to the frame.
3. Fix the back cover of the FL tube with the two screws.
4. Attach these:
• Reflective sheet
• Light guide plate (LGP)
• Diffuser sheet
• Prism sheet
5. Fasten the two clips.
6. Place the panel assembly on the correct location in the backlight assembly.
7. Place the upper chassis on the frame. Fit the hooks into the holes. There are four
hooks at the bottom, four hooks on each of the left- and right-hand sides, and six
hooks at the top.
8. Fix the power supply board with the two screws.
9. Attach the PCB cover and three pieces of tape.