Toshiba M10 - Manual (Page 195)

3.28 SETUP 3 Tests and Diagnostics
Satellite Pro M10 Series Maintenance Manual (960-431) 3-89
(f) Panel Power On/Off
This option lets you set the Panel Power On/Off function. It is effective only
in Resume mode.
Enabled Enables the Panel Power On/Off.
Disabled Disables the Panel Power On/Off (Default)
9. Configuration
This field displays the configuration method.
The devices are initialized when the PNP OS loads.
Setup by OS First, devices necessary for loading the OS will be
initialized. After the PNP OS loads, other devices will
be initialized by the OS. In this case, setup of PC Cards
will be fixed to “Auto-Selected,” and cannot be
changed. (Default)
All Devices
All devices will be initialized.
If you are using an OS that does not have PNP capacity, select “All Devices.”
The Display shows the following message:
Device Config. = All Devices
10. I/O ports
This option controls settings for the serial and parallel ports and the sound system.
NOTE: Do not assign the same interrupt request level and I/O address to the
serial port and PC card.
(a) Serial
Use this option to set the COM level for the serial port. The serial port
interrupt request level (IRQ) and I/O port base address for each COM level is
shown below: