Toshiba M10 - Manual (Page 197)

3.28 SETUP 3 Tests and Diagnostics
Satellite Pro M10 Series Maintenance Manual (960-431) 3-91
For most printers, the port should be set to ECP. With some other parallel
devices, the setting should be Std. Bi-Direct.
11. Drives I/O
This option displays the address and interrupt level for hard disk drive, CD/DVD-
ROM drive and PC card. It is for information only and cannot be changed.
(a) Built-in HDD
Primary IDE (1F0H/IRQ14) The Built-in HDD is ready for use.
No Drive The Built-in HDD is not installed.
(b) Select Bay
This option is displayed only when the hard disk drive or optical disk drive is
installed to the select bay. Secondary IDE (170H/IRQ15) Computer
Selectable Bay HDD.
(c) PC Card
When an ATA card is installed in IN13h, the sub window below is displayed.
12. PCI Bus
This item displays the interrupt level for the Card Bus. It is for information only and
cannot be changed.
PCI BUS = IRQ10, IRQ11
13. PC Card
This option displays the PC Card Controller mode. It is for information only and
cannot be changed.
Controller Mode = Auto-Selected
DMA = Channel 3 (Default)
OPTIONS
Built-in HDD = Primary IDE (1F0H/IRQ14)
ATA Card
= Others (190H/IRQ)
DRIVES I/O