Toshiba M10 - Manual (Page 109)

3.2 Executing the Diagnostic Test 3 Tests and Diagnostics
Satellite Pro M10 Series Maintenance Manual (960-431) 3-3
3.2 Executing the Diagnostic Test
Toshiba MS-DOS is required to run the DIAGNOSTICS TEST PROGRAM. To start the
DIAGNOSTIC TEST PROGRAM, follow these steps:
1. Insert the Diagnostics disk in the floppy disk drive and turn on the computer while
pressing U.
(The Diagnostics Disk contains the MS-DOS boot files.)
NOTE: To execute the CD-ROM or DVD-ROM test, make sure the CD-ROM and CD-
ROM drive or DVD-ROM and DVD-ROM drive is installed in the computer.
The following menu will appear:
TOSHIBA Personal Computer xxxxxxx DIAGNOSTICS
Version X.XX (C) Copyright TOSHIBA Corp. XXXX
DIAGNOSTICS MENU :
1 - DIAGNOSTIC TEST
2 -
3 -
4 - HEAD CLEANING
5 - LOG UTILITIES
6 - RUNNNING TEST
7 - FDD UTILITIES
8 - SYSTEM CONFIGURATION
9 - EXIT TO MS-DOS
0 - SETUP
↑↓→← : Select items
Enter: Specify
Esc : Exit
NOTE: To exit the DIAGNOSTIC TEST MENU, press Esc. If a test program is in
progress, press Ctrl + Break to exit the test program, or press Ctrl + C to stop the test
program.