Nortel Networks WEB OS 212777 - Manual (Page 96)

Web OS 10.0 Application Guide
96 n Chapter 4: OSPF
212777-A, February 2002
Configuring OSPF for Host Routes on Web Switch 2
1. Configure basic SLB parameters.
Web switch 2 is connected to two real servers. Each real server is given an IP address and is
placed in the same real server group.
2. Configure the virtual server parameters.
The same virtual servers are configured as on Web switch 1.
3. Configure IP interfaces for each network that will be attached to OSPF areas.
>> # /cfg/slb/real 1 (Select menu for real server 1)
>> Real server 1 # rip 100.100.100.27 (Set the IP address for real server 1)
>> Real server 1 # ena ble (Enable the real server)
>> Real server 1 # ../real 2 (Select menu for real server 2)
>> Real server 2 # rip 100.100.10.28 (Set the IP address for real server 2)
>> Real server 2 # ena ble (Enable the real server)
>> Real server 2 # ../group 1 (Select menu for real server group 1)
>> Real server group 1 # add 1 (Add real server 1 to group)
>> Real server group 1 # add 2 (Add real server 2 to group)
>> Real server group 1 # enable (Enable the group)
>> Real server group 1 # ../on (Turn SLB on)
>> Layer 4 # virt 1 (Select menu for virtual server 1)
>> Virtual server 1 # vip 10.10.10.1 (Set the IP address for virtual server 1)
>> Virtual server 1 # enable (Enable the virtual server)
>> Virtual server 1 # service http (Select menu for service on virtual server)
>> Virtual server 1 http service # group 1 (Use real server group 1 for http service)
>> Virtual server 2 http service # /cfg/slb/virt 2 (Select menu for virtual server 2)
>> Virtual server 1 # vip 10.10.10.2 (Set the IP address for virtual server 2)
>> Virtual server 1 # enable (Enable the virtual server)
>> Virtual server 1 # service http (Select menu for service on virtual server)
>> Virtual server 1 # group 1 (Use real server group 1 for http service)
>> Virtual server 1 # /cfg/ip/if 1 (Select menu for IP Interface 1)
>> IP Interface 1 # addr 10.10.7.2 (Set IP address on backbone network)
>> IP Interface 1 # enable (Enable IP interface 1)
>> IP Interface 1 # ../if 2 (Select menu for IP Interface 2)
>> IP Interface 2 # addr 10.10.10.41 (Set IP address on stub area network)
>> IP Interface 2 # enable (Enable IP interface 2)