Nortel Networks WEB OS 212777 - Manual (Page 285)

Web OS 10.0 Application Guide
Chapter 11: High Availability n 285
212777-A, February 2002
Stateful Failover Configuration Example
After the VRRP setup, perform the following additional steps to enable stateful failover on the
switches.
On the Master Switch
1. Enable stateful failover.
2. Set the update interval.
On the Backup Switch
1. Turn on stateful failover.
2. Set the update interval.
N OTE – The update does not have to be the same for both switches. Stateful failover supports
up to two peer switches. Repeat the steps mentioned above to enable stateful failover on all the
peer switches.
>> # /cfg/slb/sync/state ena
>> # /cfg/slb/sync/update 10 (The default is 30)
>> # /cfg/slb/sync/state ena
>> # /cfg/slb/sync/update 10 (The default is 30)