Nortel Networks WEB OS 212777 - Manual (Page 459)

Web OS 10.0 Application Guide
Chapter 17: Bandwidth Management n 459
212777-A, February 2002
11. Assign the BWM contracts to different switch ports.
Physical switch ports are used to classify which frames are managed by each contract—that is,
one BWM contract will be applied to all frames from a specific port. The second contract will
be applied to all frames from another specified port.
12. On the switch, apply and verify the configuration.
Examine the resulting information. If any settings are incorrect, make any appropriate changes.
13. On the switch, save your new configuration changes.
14. On the switch, check the BWM information.
Check that all BWM contract parameters are set correctly. If necessary, make any appropriate
configuration changes and then check the information again.
>> BWM Contract 2# /cfg/port 1/cont 1 (Assign contract 1 to port 1)
>> Port 1# ../port 2/cont 2 (Assign contract 2 to port 2)
>> Port 2# apply (Make your changes active)
>> Port 2# /cfg/bwm/cur (View current BWM settings)
>> Bandwidth Management# save (Save for restore after reboot)
>> Bandwidth Management# /info/bwm (View BWM information)