Nortel Networks WEB OS 212777 - Manual (Page 190)

Web OS 10.0 Application Guide
190 n Chapter 7: Filtering
212777-A, February 2002
8. Assign the filters to the switch port that connects to the Internet.
Web OS allows you to add and remove a contiguous block of filters with a single command.
9. Apply and verify the configuration.
Examine the resulting information. If any settings are incorrect, make appropriate changes.
10. Save your new configuration changes.
11. Check the server load balancing information.
Check that all SLB parameters are working according to expectation. If necessary, make any
appropriate configuration changes and then check the information again.
N OTE – Changes to filters on a given port do not take effect until the port’s session information
is updated (every two minutes or so). To make filter changes take effect immediately, clear the
session binding table for the port (see the
/oper/slb/clear command in the Web OS 10.0
Command Reference).
>> Filter 9# ../port 5 (Select the SLB port 5 to the Internet)
>> SLB Port 5# add 1-9 (Add filters 1-9 to port 5)
>> SLB Port 5# add 224 (Add the default filter to port 5)
>> SLB Port 5# filt enable (Enable filtering for port 5)
>> SLB Port 5# apply (Make your changes active)
>> SLB Port 5# cur (View current settings)
>> SLB Port 5# save (Save for restore after reboot)
>> SLB Port 5# /info/slb/dump (View SLB information)