Pitney Bowes DM550 - Manual (Page 66)

4-28 SV61436 Rev. B
4 • Running Mail
Adding
Postage or
Changing
the Date
8
If you do not have the correct postage or date on a piece of mail, you can
add more postage or change the date directly on a piece of mail. If you
prefer, you can print the corrections on at a tape instead and then apply it
to the piece of mail.
To add more postage
1. If you are printing more postage on an envelope and if the envelope is
sealed, press the Seal key and select Sealer Off. If you are printing on
a tape, go to step 3.
2. Turn the piece of mail around 180 degrees so that the meter stamp is
in the lower left corner as shown here. Then, place the envelope on
the feed deck with the flap facing down.
3. To add more postage, press the Mode key and select Key In Postage.
4. Enter the additional amount using the numeric keys and press Enter.
Press the Start key.
If you are printing a tape, press the Tape key.
5. The additional postage prints on the envelope as shown here.
6. If you print a tape, apply the tape to the envelope below the existing
meter stamp.
0030
00 30
0030
00 07
003 0