Pitney Bowes DM550 - Manual (Page 146)

9-10 SV61436 Rev. B
9 • Maintaining and Updating
Cleaning or
Replacing the
Wick
continued
10. Place the shield and wick
assembly in the moistener
tank and push down on
the shield to push the as-
sembly into the tank.
11. Replace the moist-
ener tank and gen-
tly slide it back into
the machine, taking
care not to crimp
the supply tubing.
To measure the
solution, position a
ruler as shown in
the picture on the
right.
12. Replace the E-Z Seal ® Seal-
ing Solution bottle. Gently tap
the top of the solution bottle.
Wait for about 5 minutes and
then check to make sure the
moistener tank is filled with
the correct amount of E-Z
Seal® solution. Measure the
amount of solution as shown
in the diagram on the right.
The solution level should be:
14 - 18 mm (0.55 - 0.71 in.)
If, after 5 minutes, the moistener tank is not filled to the correct level,
remove the E-Z Seal® bottle, wait 20 seconds and then replace it
again.
If after another 5 minutes the level is still not correct, go to step 13.
Otherwise go to step 14.
Solution level