Pitney Bowes DM550 - Manual (Page 140)

9-4 SV61436 Rev. B
9 • Maintaining and Updating
3. Drop the new tape in so that it
feeds from the bottom of the roll
to the right.
The protective backing on the
tape should be facing down.
Pull about 12 inches of tape
from the end of the roll up to-
ward the cover and then loop it
down into the slot.
CAUTION: Do not load a tape strip that has any pink or black
stripes showing. This will cause the last piece of tape to jam in
the machine which and you will need to place a service call.
4. From the “Out of Tape” or "Load Tape" screen, select Load Tape. Feed
the tape into the slot while the tape motor is running. The machine au-
tomatically cuts off the excess tape.
5. Close the feed cover.
Tape has run out
1. If the system actually runs out of tape, the “Out of Tape” screen ap-
pears.
2. Open the cover and select Unload Tape from the “Out of Tape” screen.
3. Remove any remaining tape on the tape roll. Follow steps 2 - 5 in the
Tape sti���� on ro���� procedure above.
Tape still on Roll
continued