Pitney Bowes DM550 - Manual (Page 143)

SV61436 Rev. B 9-7
DM500™and DM550™ Digital Mailing System Operating Guide
6. Replace the existing clean
moistener brush assem-
bly, or install a new one by
pushing the assembly back
on its track until it snaps
into position.
7. Check to make sure that
the flap blade of the moist-
ener brush assembly is un-
der (and not over) the strip-
per finger as shown here.
8. Verify that the moistener brush assembly is perfectly level with the feed
deck
Stripper Finger
Moistener
Brush
Assembly Feed Deck
Flap
Blade