Paradyne 7112 - Manual (Page 115)

MIB Descriptions
C-13 7112-A2-GB20-20 March 1998
DS1/E1 – RFC 1406
The unit supports DS1/E1 MIB, RFC 1406 for the T1 network interface. The DS1
Near End Group and DS1 Fractional Group are supported for this interface. The
DS1 Near End Group consists of the following tables:
H
DS1 Configuration , Table C-7
H
DS1 Current , Table C-8
H DS1 Interval , Table C-9
H
DS1 Total , Table C-10
The DS1 Far End Group is not supported.
All four tables are supported for the T1 network interface. Clarification for objects
contained in the tables as it applies to the unit is provided below.
The DS1 Far End Group is not supported.
DS1 Near End Group Configuration Table Objects
The DS1 Near End Group Configuration Table Objects contains configuration
options for the DS1/E1 interfaces. Clarification for objects contained in this table
as it applies to the unit is provided below.
Table C-7. DS1 Near End Group Configuration Table Objects (1 of 4)
Object, OID, Access Description Setting/Contents
dsx1TimeElapsed
(dsx1ConfigEntry 3 )
1.3.6.1.2.1.1.10.18.6.1.3
read-only
The number of seconds
that have elapsed since the
start of the current
error-measurement period.
Applies to the T1 network
interface only.
Supports the following
values:
H 0 to 899.
dsx1ValidIntervals
(dsx1ConfigEntry 4 )
1.3.6.1.2.1.1.10.18.6.1.4
read-only
Contains the number of
previous intervals for which
valid data was collected.
Applies to the T1 network
interface only.
Supports the following
values:
H 0 to 96.
The value is 96 unless the
interface was brought online
within the last 24 hours, in
which case the value will be
the number of complete
15 minute intervals since the
interface has been online.
dsx1LineType
(dsx1ConfigEntry 5 )
1.3.6.1.2.1.1.10.18.6.1.5
read-write
Corresponds to the network
framing configuration option
for the network interface on
the DSU/CSU. Supports the following
values:
H dsx1ESF(2) – Indicates
ESF framing.
H dsx1D4(2) – Indicates D4
framing.