Paradyne 7112 - Manual (Page 111)

MIB Descriptions
C-9 7112-A2-GB20-20 March 1998
Table C-4. Interface Stack Group Objects (2 of 2)
Object, OID, Access Setting/Contents Description
ifStackStatus
(ifStackEntry3)
1.3.6.1.2.1.31.1.2.1.3
read-only
Specifies the stack group’s
status compared to the
interface’s ifOperStatus. H When ifStackStatus set to
active – maps to ifOperStatus
set to up(1) or testing(3).
H When ifStackStatus set to not
in service – maps to
ifOperStatus set to down(2).
Interface Test Table
Not supported by the unit.
Generic Receive Address Table
Not supported by the unit.
IP Group
The Internet Protocol Group objects are supported by the unit for all data paths
that are currently configured to carry IP data to/from the unit. All of the objects in
the IP Group, except for the IP Address Translation table, are fully supported.
The following table provides clarification for objects contained in the IP group
when it is not clear how the object definition in MIB II is supported by the unit.
Table C-5. IP Group Objects (1 of 3)
Object, OID, Access Description Setting/Contents
ipForwarding (ip1)
1.3.6.1.2.1.4.1
read-write
Specifies whether the unit
is acting as an IP gateway
for forwarding of datagram
received by, but not
addressed to, the unit. Supports only the following
value:
H forwarding(1) – The unit is
acting as a gateway.
ipAddrTable (ip20)
1.3.6.1.2.1.4.20
read-only
The address table. Supported.
ipAdEntAddr
(ipAddrEntry 1)
1.3.6.1.2.1.4.20.1.1
read-only
An IP address supported by
the unit which serves as an
index to the address table. Indexes for tables must be
unique. Therefore, only one
ifIndex can be displayed for each
IP address supported by the
device. If the same IP address is
configured for multiple interfaces,
or for default IP addresses, the
ipAddrTable will not display all of
the interfaces that support a
particular IP address.