Icip bit definitions -24, Icfp bit definitions -24 – Intel PXA255 User Manual
Page 128
4-24
Intel® PXA255 Processor Developer’s Manual
System Integration Unit
4.2.2.4
Interrupt Controller IRQ Pending Register (ICIP) and FIQ Pending
Register (ICFP)
The ICIP and the ICFP, shown in
and
, contain one bit per interrupt (22 total.)
These bits indicate an interrupt request has been made by a unit. Inside the interrupt service
routine, read the ICIP and ICFP to determine the interrupt source. In general, software then reads
status registers within the interrupting device to determine how to service the interrupt. Bits within
) are read only, and represent the logical OR of the status bits in the
ICIP and ICFP for a given interrupt. Once an interrupt has been serviced, the handler writes a one
to the required status bit, clearing the pending interrupt at the source.
Clearing the interrupt status bit at the source, automatically clears the corresponding ICIP or ICFP
flag, provided there are no other interrupt status bits set within the source unit.
describes the available first-level interrupts and their location in the ICPR.
Table 4-33. ICIP Bit Definitions
Physical Address
0x40D0_0000
ICIP
System Integration Unit
Bit
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9
8
7
6
5
4
3
2
1
0
IP31
IP30
IP29
IP28
IP27
IP26
IP25
IP24
IP23
IP22
IP21
IP20
IP19
IP18
IP17
reser
ved
reser
ved
IP14
IP13
IP12
IP
11
IP10
IP9
IP8
reserved
Reset 0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0 ? ? ? ? ? ? ? ?
Bits
Name
Description
<31:8>
IP[x]
IRQ Pending x (where x = 8 through 14 and 17 through 31).
0 – IRQ NOT requested by any enabled source.
1 – IRQ requested by an enabled source.
<7:0>
—
reserved
Table 4-34. ICFP Bit Definitions
Physical Address
0x40D0_000C
ICFP
System Integration Unit
Bit
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9
8
7
6
5
4
3
2
1
0
FP31
FP30
FP29
FP28
FP27
FP26
FP25
FP24
FP23
FP22
FP21
FP20
FP19
FP18
FP17
re
ser
ved
re
ser
ved
FP14
FP13
FP12
FP1
1
FP10
FP9
FP8
reserved
Reset 0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0 ? ? ? ? ? ? ? ?
Bits
Name
Description
<31:8>
FP[x]
FIQ Pending x (where x = 8 through 14 and 17 through 31).
0 – FIQ NOT requested by any enabled source.
1 – FIQ requested by an enabled source.
<7:0>
—
reserved