Aiming duration timer, Default – Datalogic QuickScan I QD2400 User Manual
Page 94
Enter/Exit Programming Mode
Scanning Features
84
QuickScan™ I QD24XX/QBT24XX/QM24XX
Aiming Duration Timer
Specifies the frame of time the aiming pointer remains on after decoding a label, when in trig-
ger single mode.The range for this setting is from 1 to 255 seconds in 1-second increments.
in “References” for a description of this feature.
DEFAULT
LSTM00
Aiming Off After Decoding
LSTM
Set Aiming Duration Timer
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left followed
by the digits from the Alphanumeric characters in
representing your desired
character(s). End by scanning the ENTER/EXIT bar code.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL