Datalogic QuickScan I QD2400 - Manual (Page 293)

Product Reference Guide 283
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of the table below.
Page references are also provided for feature descriptions and programming bar codes for each
parameter. A column has also been provided for recording of your preferred default settings for
these same configurable features.
Table 50. Standard Defaults
Parameter Default Your Setting
Page
Number
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore
Obey 27
USB Suspend Mode
Disable 27
RS-232 ONLY
Baud Rate
9600 30
Data Bits
8 Data Bits 31
Stop Bits
1 Stop Bit 31
Parity
None 32
Handshaking Control
RTS 33
RS-232/USB-COM
Intercharacter Delay
No Delay 35
Beep On ASCII BEL
Disable 35
Beep On Not on File
Enable 36
ACK NAK Options
Disable 36
ACK Character
‘ACK’ 37
NAK Character
‘NAK’ 37
ACK NAK Timeout Value
200 ms 38
ACK NAK Retry Count
3 Retries 38
ACK NAK Error Handling
Ignore Errors Detected 39
Indicate Transmission Failure
Enable 39