Led and beeper indicators, Power on alert, Good read: when to indicate – Datalogic QuickScan I QD2400 User Manual
Page 82: Power on alert good read: when to indicate, Eeper, Ndicators, Default
Enter/Exit Programming Mode
LED and Beeper Indicators
72
QuickScan™ I QD24XX/QBT24XX/QM24XX
LED AND BEEPER INDICATORS
Power On Alert
Disables or enables the indication (from the Beeper) that the reader is receiving power.
$CBPPU00(CR)
Power On Alert = Disable (No Audible Indication)
$CBPPU01(CR)
Power On Alert = Power-up Beep
DEFAULT
Good Read: When to Indicate
This feature specifies when the reader will provide indication (beep and/or flash its green LED)
upon successfully reading a bar code.
DEFAULT
$CBPIN00(CR)
Indicate Good Read = After Decode
$CBPIN01(CR)
Indicate Good Read = After Transmit
$CBPIN02(CR)
Indicate Good Read =
After CTS goes inactive then active