Datalogic QuickScan I QD2400 - Manual (Page 22)

Setup
12 QuickScan™ I QD24XX/QBT24XX/QM24XX
Figure 6. Other Interface Connections
W
an
d
IB
M
K
ey
bo
ard
W
edg
e
or...
or...
NOTE
Specific cables are required for connection to different hosts. The connectors illustrated
above are examples only. Actual connectors may vary from those illustrated, but the steps
to connect the reader remain the same.
Cordless Models
The power supply connects directly to the base (not on the cable's jack) for all configurations.
For all interfaces (except RS-232) a power supply is recommended but not necessary, because
the base can be powered from the Host. When the base is powered from the Host, it automati-
cally selects a slow charge rate.
Configuring the Base Station
Connecting the Base Station
Figure 7 on page 14 shows how to connect the Base Station to a terminal, PC or other host
device. Turn off the host before connection and consult the manual for that equipment (if nec-
essary) before proceeding. Connect the interface cable before applying power to the Base Sta-
tion.
NOTE
The QuickScan QM/QBT24XX can also be Powered by the Terminal. When powered by the Ter-
minal, the battery charger is automatically set as Slow charge.
For some specific interfaces or hosts or lengths of cable, the use of an external power supply
may be recommended for full recharging capability (see
"Technical Specifications"
on
page 273 for more details).