Ack character, Nak character, Ack character nak character – Datalogic QuickScan I QD2400 User Manual
Page 47: Ack c, Haracter, Nak c, Default
RS-232/USB-Com Interfaces
Enter/Exit Programming Mode
Product Reference Guide
37
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See
for more information.
NOTE
$CR2AC
Select ACK Character Setting
DEFAULT
0x06 ‘ACK’ Character
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with
normal operation of these characters. 8-bit data is not recognized when the option
has been set as 7 Data Bits.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII
characters or any hex value from 0 to 0xFF can be selected.
NOTE
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with
normal operation of these characters. 8-bit data is not recognized when the option
has been set as 7 Data Bits.
for more information.
$CR2NA
Select NAK Character Setting
DEFAULT
0x15 ‘NAK’ Character