Interface selection, Setting the interface, And s – Datalogic QuickScan I QD2400 User Manual
Page 28
Setup
18
QuickScan™ I QD24XX/QBT24XX/QM24XX
Interface Selection
Upon completing the physical connection between the reader and its host, proceed to Table 1
to select the interface type the reader is connected to (for example: RS-
232, Keyboard Wedge, USB, etc.). Scan the appropriate bar code in that section to configure
your system’s correct interface type.
Setting the Interface
Scan the programming bar code from this section which selects the appropriate interface type
matching the system the reader will be connected to. Next, proceed to the corresponding sec-
tion in this manual (also listed in
) to configure any desired settings and fea-
tures associated with that interface.
NOTE
Unlike some programming features and options, interface selections require that
you scan only one programming bar code label. DO NOT scan an ENTER/EXIT bar
code prior to scanning an interface selection bar code.
Some interfaces require the scanner to start in the disabled state when powered up.
If additional scanner configuration is desired while in this state, pull the trigger and
hold it for five seconds. The scanner will change to a state that allows programming
with bar codes.
Table 1. Available Interfaces
RS-232
FEATURES