Bt-only features, Bt pin code – Datalogic QuickScan I QD2400 User Manual
Page 282
References
272
QuickScan™ I QD24XX/QBT24XX/QM24XX
BT-Only Features
BT Pin Code
This option specifies the 4-character or 16-character pin code to be used for authentication of
the BT
link.
To set the pin code:
1.
Scan the
ENTER/EXIT PROGRAMMING MODE bar code to enter Programming Mode, then
enable
2.
Specify the desired pin code length (4 or 16) by scanning the appropriate bar code in
3. Determine the desired characters. For example, D254 or
STOR12345678135M
4. Convert the characters to hexadecimal using the
on the inside back cover of
this manual.
and Scan the bar code: SET 4 CHAR PIN CODE or SET 16-CHAR PIN CODE.
6. Scan the appropriate alphanumeric characters from the keypad in
,
representing the hexadecimal entries determined in the steps above. You will hear a two-
beep indication after the last character.
NOTE
If you make a mistake before the last character, scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the beginning.
7. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
NOTE
Changing the pin code setting will unlink the devices. If the Automatic Configuration Update
is set to the default enabled setting, the devices must only be relinked. If the Automatic Con-
figuration Update is set to the disabled setting, the Pin Code setting must also be updated in
the Base Station using Aladdin. After the Base Station has been updated, the devices must be
relinked.
Figure 13. BT Pin Code Setting Examples
STEP
ACTION
EXAMPLES
1
Desired Setting
D254
STOR12345678135M
2
Convert the characters to
hexadecimal
44 32 35 34
53 54 4F 52 31 32 33 34 35 36 37 38 31 33 35 4D
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SET BT PIN CODE
5
Scan 8 or 32 Alphanumeric
Characters From
44323534
53544F5231323334353637383133354D
6
Scan ENTER/EXIT PROGRAMMING MODE