Datalogic QuickScan I QD2400 - Manual (Page 57)

Keyboard Settings Enter/Exit Programming Mode
Product Reference Guide 47
Wedge Quiet Interval
Specifies amount of time to look for keyboard activity before scanner breaks keyboard connec-
tion in order to transmit data to host. The selectable range for this setting is 00 to 990 millisec-
onds (00-0x63 by 01) in increments of ten milliseconds. See page 248 in “References” for
detailed information and examples for setting this feature.
$CKBQI
Set Wedge Quiet Interval
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT 0A = Quiet Interval is 100 milliseconds
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The selectable
range for this feature is from 0 to 99 seconds.
See
page 250 in “References” for detailed information and examples for setting this feature.
$CKBID
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT 00 = No Wedge Intercode Delay