Yaskawa MP900 Series Machine Controller Programming Panel for Simple Operation - Manual (Page 85)

3.2 Operation of Controller Configuration
3-15
3
„ MP920
The number of tabs corresponding to the number of SVBs set in Setup Wizard 4: Module
Configuration Window will be displayed.
Each tab name will be given like ††:SVB-01.
Note: Replace †† with the Motion Module number in actual operation.
The following illustration shows an example of two SVBs allocated to Motion Module num-
bers 03 and 04.
Motion Module numbers will be allocated automatically in numerical order (e.g., 01, 02, and so on) to
all Servo Modules set in
Setup Wizard 4: Module Configuration Window .
„ MP930
No tabs will be used.
„ MP940
No tabs will be used. Only a single axis will be used.
INFO