Yaskawa MP900 Series Machine Controller Programming Panel for Simple Operation - Manual (Page 100)

4.3 Default Data
4-15
4
1. The H01 drawing will not be generated and the operating status of the H01 drawing or
program hold will not be displayed if the check box to create a basic ladder program
automatically in the Setup Wizard 2: Definition Window has not been checked.
In this case, the present value of the A axis will be displayed in number 1, followed by
the present value of the B axis in number 2 and that of the C axis in number 3.
2. The Position page will display the present value of each axis that has been set.
These axes refer to all axes defined as controller configuration items.
Axis definition data will be created based on the settings in the Setup Wizard 4: Module
Configuration Window. Refer to 3.2.4 Module Information.
3. The register numbers of the present values of each axis will be assigned in 2-word incre-
ments (long size) beginning with ML00010.
The data will be displayed in a long format.
4. The comment on each axis consists of the logical axis name and the present value of the
axis program.
As defined, the logical axis names will be A, B, C, etc.