Yaskawa MP900 Series Machine Controller Programming Panel for Simple Operation - Manual (Page 49)

2.4 MP930 Setup Wizard
2-37
2
2.4.2 Definitions
The Definition Window is described in detail below.
Fig 2.12 Setup Wizard 2: Definition
1. Define System Modules
Select the name of the module setting template from the drop-down list.
The comment set in the selected module setting template will appear under the box.
1 Select the new user definition when setting a new Module.
2 If there is a registered MP930 module setting template, the defined names will be listed together with a
selection for a new user definition. If a MP930 module setting template has not been registered, only a
selection for a new user definition will appear. After the installation, four module setting templates are
prepared as shown in Fig. 2.12.
2. Check Box to Modify System Modules
Check the box if the module settings need changes.
Changes in the Setup Wizard 4: Module Configuration Window will be possible only if
this box is checked.
The above operation is possible only if a registered module setting template has been selected instead
of a new user definition.
1.
2.
3.
4.
8.
5. 6. 7.
INFO
INFO