Yaskawa MP900 Series Machine Controller Programming Panel for Simple Operation - Manual (Page 138)

8.1 Comments on Setup Wizard
8-3
8
8.1.2 Pop-up Help Menu
This section explains the contents of the pop-up help that will be displayed with the mouse
cursor located.
„ Module Configuration Window
The following pop-up help menu items will appear when the cursor is located on the icon of
each Module in the Setup Wizard 4: Module Configuration Window.
Item Kind Comment
Module
configu-
ration Short/Long
rack Set the rack for set the module.
Possible to set maximum 4 racks.
CPU CPU module
This has to be set on the 1st rack.
EXIF Module for the connecting between a module and a module
Required for setting more than 2 racks.
SVA1 Analog servo module
Possible to control the 4 axes.
This uses 2 slots.
SVA2 Analog servo module
Possible to control the 2 axes.
SVB1 Network digital servo module
Possible to control the 14 axes with MECHATROLINK.
PO Pulse output module
Possible to control the 4 axes of the pulse motors.
AI Analog input module
The analog input number are 8.
AO Analog output module
The analog output number are 4.
CNTR Counter module
The pulse input number are 4.
DI Digital input module
The digital input number are 64.
DO Digital output module
The digital output number are 64.
LIO Local I/O module
This has 32 digital inputs and 32 digital outputs.
215IF 215 I/F module
Connectable to the CP-215 N to N communication.
217IF 217 I/F module
Serial I/F and possible to connect RS-232C, RS-485.
218IF 218 I/F module
ETHERNET protocol
216IF DeviceNet module
Connect the DeviceNet module.