Yaskawa MP900 Series Machine Controller Programming Panel for Simple Operation - Manual (Page 110)

4.4 Editing Data
4-25
4
4.4 Editing Data
Data in Quick Reference can be edited to change displayed pages or data, or to set data in regis-
ters.
This section provides detailed information on each function.
4.4.1 Editing Pages
Pages displayed in Quick Reference can be edited.
The following editing items are available.
Refer to 4.2 Using Quick Reference for editing pages in detail.
4.4.2 Registers Accepting Input
In Quick Register, data can be input into the following registers.
The D register is a unique register of each drawing. Therefore, when the D register is set, the
DWG name must be set as well.
The number of D registers that are available corresponds to those set in DWG definition.
The number of any other registers available corresponds to the maximum number shown in
the table.
Item Description
Adding pages Adds a new page to Quick Reference.
Deleting pages Deletes a page from Quick Reference.
Changing displayed
pages Specifies a page to be displayed.
Changing titles Changes the title of a page.
Copying pages Copies a page (watch pages only).
Cutting pages Cuts a page (watch pages only).
Pasting pages Pastes the copied or cut page (watch pages only).
Register
Variable
Maximum Number
Read/Write
MP910 MP920 MP930 MP940
S register 1024 1024 1024 1024 R/W
I register 5120 5120 2048 2048 R/W
O register 5120 5120 2048 2048 R/W
M register 32768 32768 32768 32768 R/W
D register 16384 16384 16384 16384 R/W
C register 16384 16384 16384 16384 Read only