Yaskawa MP900 Series Machine Controller Programming Panel for Simple Operation - Manual (Page 120)

Motion Parameters
5.1.2 Display of Motion Parameter Window
5-4
5
MP920
The Motion Parameter Dialog Box will be displayed as shown below.
In the Dialog Box, the rack configuration consisting of racks or Modules set in the Setup
Wizard 4: Module Configuration Window will be displayed. The following illustration is an
example of the Motion Parameter Dialog Box.
Use method 1 or 2 below.
1. Double-click the Motion Module icon in the Dialog Box or click the Motion Module
icon and then the Open Button.
The Motion Parameter Window of the Servo Module selected will be displayed in the
Engineering Manager and the Motion Parameter Dialog Box will close.
2. Click the Close Button.
The Motion Parameter Dialog Box will close. The Motion Parameter Window will not
be displayed.
MP930 or MP940
The Motion Parameter Window will be displayed.
To log onto the Controller folder, refer to the Machine Controller MP900 Programming Software User’s
Manual for standard operation (SIEZ-C887-2.4).
1.
2.
INFO