Yaskawa MP900 Series Machine Controller Programming Panel for Simple Operation - Manual (Page 115)

Quick Reference
4.4.5 Editing Watch Page Data
4-30
4
• Data: The number of the register where data is displayed or set.
• Set value: Input the register number.
2. DWG Name
• Data: The name of the DWG where the register number exists.
• Set value: Input the DWG name.
If the D register is set for the register number, be sure that the D register is
set because the D register is a unique register of the DWG. Any other set
value will be ignored.
3. DSP Type
• Data: Display format of register data.
• Set value: Select the display format of data from the drop-down list. The following
values can be selected.
4. Data (Register Data)
• Data: Present register data
• Set value: Input the value according to the format set in DSP type.
The data set here will be reflected as register data.
5. Symbol
• Data: The symbol (name) corresponding to the register number.
• Set value: Input the name (symbol) corresponding to the register data. The name
input here will be displayed above the register number on the drawing
specified by the DWG Name.
6. Comment
• Data: Comment on data.
• Set value: Input the comment on the register data.
Up to 48 characters can be input.
Register Number Setting Selection Display/Value
Binary Possible BIN ON/OFF display
Word Possible DEC Decimal display
HEX Hexadecimal display
BIN Binary display
Long Possible LONG Long (4-byte) display
HEX Hexadecimal display
Float Possible FLOAT Floating-point display