Yaskawa MP900 Series Ladder Programming Manual - Manual (Page 80)

5.2 Relay Circuit Instructions
5.2.5 1-s ON-Delay Timer (TON[1s])
5-11
Instructions
5
5.2.5 1-s ON-Delay Timer (TON[1s])
( 1 ) Operation
The timer counts the time whenever the timer bit input is 1 (ON). The bit output is set to 1 (ON) when the count value
equals the set value.
If the bit input changes to 0 (OFF) during counting, the timer will stop counting. If the bit input changes to 1 (ON)
again, the timer starts counting again from the beginning (i.e., from 0). The actual counted time (in units of 1 s) is
stored in the Count register.
ΠThe counting error is 1 s or less.
( 2 ) Format
∗ C and # registers cannot be used.
Bit input
Count value
Set value
0
Bit output
1 (ON)
0 (OFF)
1 (ON)
0 (OFF)
Timer Bit input →
The set value and count value are in units of 1 s.
→ Bit output
Parameter Name
Applicable Data Types
B W L F A Index Constant
Set value (Set) × { × × × × {
Count value (Count) × { * × × × × ×
Set value
Count value
Icon:
Key entry: [SON