Yaskawa MP900 Series Ladder Programming Manual - Manual (Page 63)

4.5 Table Data
4.5.2 Creating Table Data
4-22
„
Procedure to Create Table Data
1.
Select File - Open − Define Data Table − Data Table Map in the Module Configuration Definitions
Window. The Table Data Store Target Dialog Box will be displayed.
2.
Select File − Create New from the menu bar. The Table Definition Dialog Box will be displayed. Set the
table definition information and click the OK Button.
3. The Data Table Column Attribute Dialog Box will be displayed. Set the table data column attributes,
and then save them.
ΠIf the table is set to an array-type table, set only one row of column attributes.
The Table Data Store Target Dialog Box that was displayed in step 1 will show the table that you created.
This concludes the creation of the data table.
When a table is created, the contents are initialized to 0.
Select the table that was created in the Table Data Store Target Dialog Box, and click the Table Data Button to read or write
table data.
Use the table instructions to perform operations on the table data from a ladder program.
INFO