Yaskawa VS-616G5 Modbus Plus Communication Card User Manual

Page 13

Installation of the MB+ Board 3-3

Figure 3-1. MB+ Board Mounting Position

7. Locate the green grounding wire with mounting lug on the MB+ board. Route this wire to the

lower corner of the drive control board.

8. Connect the green wire (labeled “E”) to terminal 12 on the drive.

NOTE:

You have completed the mechanical installation of the MB+ board. Proceed to the MB+

board configuration prior to applying input power or replacing the VS-616G5 front cover.

Spacer
Holes

Ground
Terminal
(term. 12)

DIP Switch
SW1

Connector
2CN

Main
Control
Terminals

Modbus
Plus
Interface
Board